“02_2.led” - NO.3 program for No.2 controller “01_2.led” - NO.2 program for No.2 controller “00_2.led” - NO.1 program for No.2 controller “15_1.led” - NO.16 program for No.1 controller “02_1.led” - NO.3 program for No.1 controller “01_1.led” - NO.2 program for No.1 controller “00_1.led” - NO.1 program for No.1 controller
#LED EDIT 2014 SOFTWARE FOR MAC HOW TO#
Name of the program: ( The rule of how to name the programs)
#LED EDIT 2014 SOFTWARE FOR MAC CODE#
If you need to control a new IC type by the controller, the software code mode is the T-1000-IC model.Ħ. If you need to use RS485 signal you need to connect controller A interface with LED lamps A (DMX+), controller Bĥ. If the chip for LED is a double line chip with DAT and CLK, then need to be connected with DAT, CLK, andĤ. When the chip for LED is a single line chip just with data, then just needs to be connected with the DAT and GND of theĬontroller. T-1000S one TTL(SPI) signal and one RS485 signal port output, can control 2048 pixels/lamps；ģ.
Multiple T-1000S controllers can be cascaded together and work synchronously.Ģ. NOTE: For the TTL(SPI) signal, the controller signal ground must connect to the LED ground directly.
T-1000S must use the new software LedEdit 2012. When the T-1000S controls more than 512 lamps and less than 2048 lamps the frame rate will slow down automatically.Ģ. When the T-1000S controller control less than 512 lamps the frame rate can reach 30fps. Compatible with a single line or double line chips.ġ. Off-line(SD Card) control, playback content stored in the SD card.ĥ.T-1000S stores a maximum of 16 programs, copy multiple files to the SD card in order,Īfter formatting the SD card as “FAT” format.Ħ. Single-port output, can support 2048 pixels。Ĥ. Support the rules and special-shaped handle.ģ. 32-256 Gray level, Support software Gamma correction。Ģ.
0 kommentar(er)
